Internet Data Sheet

Rev. 1.2, 2007-04

4

04112007-FHBX-O8HD

HYB25DC512[80/16]0B[E/F]

Double-Data-Rate SDRAM

1.2

Description

The 512-Mbit Double-Data-Rate SDRAM is a high-speed CMOS, dynamic random-access memory containing 536,870,912 bits.

It is internally configured as a quad-bank DRAM.

The 512-Mbit Double-Data-Rate SDRAM uses a double-data-rate architecture to achieve high-speed operation. The double

data rate architecture is essentially a 2n prefetch architecture with an interface designed to transfer two data words per clock

cycle at the I/O pins. A single read or write access for the 512-Mbit Double-Data-Rate SDRAM effectively consists of a single

2n-bit wide, one clock cycle data transfer at the internal DRAM core and two corresponding n-bit wide, one-half-clock-cycle

data transfers at the I/O pins.

A bidirectional data strobe (DQS) is transmitted externally, along with data, for use in data capture at the receiver. DQS is a

strobe transmitted by the DDR SDRAM during Reads and by the memory controller during Writes. DQS is edge-aligned with

data for Reads and center-aligned with data for Writes.

The 512-Mbit Double-Data-Rate SDRAM operates from a differential clock (CK and CK; the crossing of CK going HIGH and

CK going LOW is referred to as the positive edge of CK). Commands (address and control signals) are registered at every

positive edge of CK. Input data is registered on both edges of DQS, and output data is referenced to both edges of DQS, as

well as to both edges of CK.

Read and write accesses to the DDR SDRAM are burst oriented; accesses start at a selected location and continue for a

programmed number of locations in a programmed sequence. Accesses begin with the registration of an Active command,

which is then followed by a Read or Write command. The address bits registered coincident with the Active command are used

to select the bank and row to be accessed. The address bits registered coincident with the Read or Write command are used

to select the bank and the starting column location for the burst access.

The DDR SDRAM provides for programmable Read or Write burst lengths of 2, 4 or 8 locations. An Auto Precharge function

may be enabled to provide a self-timed row precharge that is initiated at the end of the burst access. As with standard SDRAMs,

the pipelined, multibank architecture of DDR SDRAMs allows for concurrent operation, thereby providing high effective

bandwidth by hiding row precharge and activation time.

An auto refresh mode is provided along with a power-saving power-down mode. All inputs are compatible with the Industry

Standard for SSTL_2. All outputs are SSTL_2, Class II compatible.

Note: The functionality described and the timing specifications included in this data sheet are for the DLL Enabled mode of

operation.