| Motore di ricerca datesheet componenti elettronici |
|
FDMS8672AS Scheda tecnica(PDF) 19 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
FDMS8672AS Scheda tecnica(HTML) 19 Page - Texas Instruments |
|
19 / 43 page ![]() DETAILED DESCRIPTION ENABLE AND SOFT START 200ms 960ms Vout1 EN1 EN1 Vout1 External Soft-start time EN1>1V EN1<2V 1)Internal Soft-start 2)External Soft-start 3.3-V, 10-mA LDO (VREG3) 2-V, 100- µA Sink/Source Reference (VREF2) TPS51222 www.ti.com............................................................................................................................................................................................... SLUS908 – JANUARY 2009 When EN is Low, the TPS51222 is in the shutdown state. Only the 3.3-V LDO stays alive, and consumes 7 µA (typically). When EN becomes High, the TPS51222 is in the standby state. The 2-V reference and the 5-V LDO become enabled, and consume about 80 µA with no load condition, and are ready to turn on SMPS channels. Each SMPS channel is turned on when ENx becomes High. After ENx is set to high, the TPS51222 begins the softstart sequence, and ramps up the output voltage from zero to the target voltage in 0.96 ms. However, if a slower soft-start is required, an external capacitor can be tied from the ENx pin to GND. In this case, the TPS51222 charges the external capacitor with the integrated 2- µA current source. An approximate external soft-start time would be tEX-SS = CEX / IEN12, which means the time from ENx = 1 V to ENx = 2 V. The recommend capacitance is more than 2.2 nF. Figure 38. Enable and Soft-start Timing Table 1. Enable Logic States EN EN1 EN2 VREG3 VREF2 VREG5 CH1 CH2 GND Don’t Care Don’t Care ON Off Off Off Off Hi Lo Lo ON ON ON Off Off Hi Hi Lo ON ON ON ON Off Hi Lo Hi ON ON ON Off ON Hi Hi Hi ON ON ON ON ON A 3.3-V, 10-mA, linear regulator is integrated in the TPS51222. This LDO services some of the analog circuit in the device and provides a handy standby supply for 3.3-V Always On voltage in the notebook system. Apply a 2.2- µF (at least 1-µF), high quality X5R or X7R ceramic capacitor from VREG3 to (signal) GND in adjacent to the device. This voltage is used for the reference of the loop compensation network. Apply a 0.22- µF (at least 0.1-µF), high-quality X5R or X7R ceramic capacitor from VREF2 to (signal) GND in adjacent to the device. Copyright © 2009, Texas Instruments Incorporated Submit Documentation Feedback 19 Product Folder Link(s) :TPS51222 |
|
Link URL |
| Lei ha avuto il aiuto da alldatasheet? [ DONATE ] |
Di alldatasheet | Richest di pubblicita | contatti | Privacy Policy | Collegamento alla scheda tecnica | scambio Link | Ricerca produttore All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |