Gravity: Analog Signal Isolator

SKU:DFR0504

 

 

INTRODUCTION

The Analog Signal Isolator can isolate analog signal and provide isolated power to sensors. It can effectively prevent

sensor signal interference and apply to multi-parameter water quality monitoring sensors. Because usually sensors

will be interfered by the other sensors during the measurement, especially those sensors in water quality monitoring

system. For example, pH sensor (pH meter) will be affected by the electrical conductivity sensor (EC meter).

The common solution is to isolate the power supply. Once you put them into the same container and share the same

power supply, their value won’t be interfered by each other.This analog signal isolator is designed for this situation, it

will isolate the analog signal and provide isolated power to the sensors. It has an on-board 5V isolated power IC, and

compatible with Gravity-3Pin interface, plug and play, no need for soldering. The transform rate is 1:1, which means

analog values in two sides should remain the same.