L9959 datasheet(23/49 Pages) STMICROELECTRONICS

23 / 49 page

DocID027540 Rev 3

23/49

L9959

Application information

4.1

Power stage switching behavior

The L9959 output stages can either be controlled by the pins PWM and DIR or by their

corresponding SPI registers (SPWM and SDIR: see Table 33 in Configuration Register

(CONFIG_REG)). The SPI bit MUX in the configuration register (CONFIG_REG) is used to

define the driving control strategy of the H-bridge. If the power stages are disabled by /ABE

or DIS, this bit is reset and the pins PWM and DIR control the outputs.

The active free-wheeling, in which the body diode is actively shorted by its associated

Power-MOS, can be disabled by the bit FW in the configuration register (CONFIG_REG).

By default, active free-wheeling is enabled.

The device minimizes electro-magnetic emission by switching the high-side and low-side

drivers in a special sequence. Two cases are distinguished: The PWM-mode, during which

the current direction does not change and the direction switches using the DIR, which

changes the current direction (see Figure 10, Figure 12 and Figure 13).

4.1.1

PWM mode (same current direction)

The PWM input pin switches the high-/low-side output of the half-bridge, which is selected

by the DIR pin.

DIR = '0': OUT1 is switched, DIR = '1': OUT2 is switched.

PWM = '0': Switched low-side is on, PWM = '1': Switched high-side is on.

Figure 10. PWM mode current flow

L9959 Scheda tecnica(PDF) 23 Page - STMicroelectronics