L9965P-FP datasheet(21/104 Pages) STMICROELECTRONICS

21 / 104 page

3.4.3

Wake-up via peripheral SPI

The IC can be woken up by any valid SPI frame. A wake-up condition is acknowledged when the following pattern

is received:

1. A NCS high to low transition

2. 24 SCK pulses

3. A NCS low to high transition

To prevent the logic being stuck in the wake-up detection state upon incomplete patterns, the

tSPI_WAKEUP_TIMEOUT is started upon every NCS assertion, and the wake-up pattern shall end before timeout

expiration, otherwise it is discarded.

Wake-up frames are not decoded, so their content may be arbitrary.

Note:

It is strongly recommended to send READ commands to avoid inadvertent write operations in case the device is

already awake.

When a correct wake-up sequence is acknowledged, the event is latched in the SPI_WAKEUP bit located in the

INTERNAL_STATUS register. The latch-set pulse also triggers the start of the tSPI_COMM_TIMEOUT communication

timeout. Such a timer is intended to avoid the IC being left unintendedly in a high consumption power state in

case the controller is unresponsive:

•

The tSPI_COMM_TIMEOUT is reset and restarted in case a valid frame is received (no CRC error and correct

number of SCK pulses).

•

The tSPI_COMM_TIMEOUT is reset and stopped in case a high level is detected on CWUP. From that moment

on, moving the device to a low power state requires setting CWUP low.

Figure 5. Wake-up condition by peripheral SPI

VALID

NCS

DISCARDED

tSPI_WAKEUP_TIMEOUT

t=0

SCLK

3.4.3.1

SPI wake-up electrical parameters

All parameters are tested and guaranteed in the following conditions, unless otherwise noted: all supplies

according to the Table 3; TJ according to the Table 2.

Table 16. SPI electrical parameters

Symbol

Parameter

Test condition

Min Typ Max Unit

tSPI_WAKEUP_TIMEOUT

Timeout for receive of wake-up

frame

Guaranteed by SCAN

0.4

NCS, SDI,

SDO, SCLK

tSPI_COMM_TIMEOUT

Communication timeout started

in case of wake-up via

peripheral SPI

Guaranteed by SCAN

NCS, SDI,

SDO, SCLK

tSPI_WAKEUP_TIME

IC wake-up latency

From the NCS low to high

transition to the IC in

NORMAL (full NVM

download)

NCS, SDI,

SDO, SCLK

L9965P

Functional description

DS14702 - Rev 4

page 21/104

L9965P-FP Scheda tecnica(PDF) 21 Page - STMicroelectronics

L9965P-FP Scheda tecnica(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Scheda tecnica Scarica

Link URL