TLV752 datasheet(3/31 Pages) TI2

3 / 31 page

FB1

GND

EN1

GND

EN2

IN2

FB2

OUT2

IN1

OUT1

Not to scale

Thermal

Pad

TLV752

www.ti.com

SBVS383A – DECEMBER 2019 – REVISED MARCH 2020

Product Folder Links: TLV752

Submit Documentation Feedback

5 Pin Configuration and Functions

DSQ Package

10-Pin Adjustable WSON

Top View

Pin Functions

I/O

DESCRIPTION

NAME

NO.

EN1

Input

Enable pin. Drive EN1 greater than VEN1(HI) to turn on the regulator.

Drive EN1 less than VEN1(LO) to put the low-dropout (LDO) regulator into shutdown mode.

EN2

Input

Enable pin. Drive EN2 greater than VEN1(HI) to turn on the regulator.

Drive EN2 less than VEN2(LO) to put the LDO into shutdown mode.

FB1

—

This pin is used as an input to the control loop error amplifier and is used to set the

output voltage of the LDO.

FB2

—

This pin is used as an input to the control loop error amplifier and is used to set the

output voltage of the LDO.

GND

2, 4

—

Ground pin

IN1

Input

Input pin. For best transient response and to minimize input impedance, use the

recommended value or larger ceramic capacitor from IN to ground; see the

Recommended Operating Conditions table and the Input and Output Capacitor Selection

section. Place the input capacitor as close to the output of the device as possible.

IN2

Input

Input pin. For best transient response and to minimize input impedance, use the

recommended value or larger ceramic capacitor from IN to ground; see the

Recommended Operating Conditions table and the Input and Output Capacitor Selection

section. Place the input capacitor as close to the output of the device as possible.

OUT1

Output

Regulated output voltage pin. A capacitor is required from OUT to ground for stability.

For best transient response, use the nominal recommended value or larger ceramic

capacitor from OUT to ground; see the Recommended Operating Conditions table and

the Input and Output Capacitor Selection section. Place the output capacitor as close to

output of the device as possible.

OUT2

Output

Regulated output voltage pin. A capacitor is required from OUT to ground for stability.

For best transient response, use the nominal recommended value or larger ceramic

capacitor from OUT to ground; see the Recommended Operating Conditions table and

the Input and Output Capacitor Selection section. Place the output capacitor as close to

output of the device as possible.

Thermal pad

Pad

—

Connect the thermal pad to a large area GND plane for improved thermal performance.

TLV752 Scheda tecnica(PDF) 3 Page - Texas Instruments

TLV752 Scheda tecnica(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Scheda tecnica Scarica

Link URL