MPL460AT-ISLASH4LB datasheet(39/48 Pages) MICROCHIP

Il numero della parte	MPL460AT-I/4LB

Spiegazioni elettronici	programmable modem designed for narrow-band Power Line Communication (PLC)

PDF	48 Pages

Scroll/Zoom	100%

Produttore elettronici	MICROCHIP [Microchip Technology]

Homepage	http://www.microchip.com

Logo

39 / 48 page

PL460

Electrical Characteristics

Data Sheet

DS60001666D - 39

11.8. Power On Considerations

The Power On procedure begins by driving the ENABLE pin high to activate the embedded voltage

regulator.

When the ENABLE pin is driven high, VDDCORE is activated once the ENABLE voltage reaches 1.6V.

The NRST pin must be tied to ‘0’ during power-on for a minimum of 2.5 ms after the VDDCORE is

activated.

Clock signals will begin operating approximately 290 μs after the NRST pin is released. Following

this, the external host CPU can access the bootloader logic to transfer the program and initiate

system operation.

Figure 11-2. Power On Timing Diagram for NRST (ENABLE With Pull-Up Resistor to VDDIN)

0,5

1,5

2,5

3,5

0,5

1,5

2,5

3,5

4,5

ENABLE

VDDCORE

NRST

2,5 ms

It is recommended to apply the PVDDAMP supply at least 2.5 ms after the ENABLE pin has stabilized.

Figure 11-3. Power On Timing Diagram for PVDDAMP (ENABLE With Pull-Up Resistor to VDDIN)

0,5

1,5

2,5

3,5

4,5

ENABLE

VDDCORE

PVDDAMP

2,5 ms

If these considerations about NRST and PVDDAMP cannot be met, Microchip strongly recommends

holding the NRST pin low as soon as possible at power on.

MPL460AT-I/4LB Scheda tecnica(PDF) 39 Page - Microchip Technology