5

3) Prepare the filament

4) Start the print

5) Post process

When the print begins make sure the first layer is correctly laid down and

sticking well to the bed before leaving the printer to finish the print.

PolyLite™ ASA can be wet sanded to obtain a smoother surface.

PolyLite™ ASA can be chemically smoothed with acetone. We highly

recommend to use our

PolySmooth™ filament for this purpose as it can

be smooth with IPA which is safer to manipulate than acetone.

- Carefully open the resealable bag, remove the spool and close the bag

back to preserve the desiccant bag.

- It is recommended to store

PolyLite™ ASA in the PolyBox™ to prevent

moisture absorption which will lower the quality and the mechanical

properties of the print.

- Load the filament in your printer and wait until you have a consistent

extrusion.

- At the end of the print, make sure to correctly store the filament back in

the resealable bag if you are not using the

PolyBox™.