PS9151 e

R08DS0108EJ0301 Rev.3.01

Page 9 of 12

May 30, 2018

NOTES ON HANDLING

1. Recommended soldering conditions

(1) Infrared reflow soldering

• Peak reflow temperature

260

C or below (package surface temperature)

•

Time of peak reflow temperature

10 seconds or less

• Time of temperature higher than 220

C

60 seconds or less

• Time to preheat temperature from 120 to 180

C

120

30 s

• Number of reflows

Three

• Flux

Rosin flux containing small amount of chlorine (The flux

with a maximum chlorine content of 0.2 Wt% is

recommended.)

220°C

Time (s)

(heating)

to 10 s

to 60 s

260°C MAX.

Recommended Temperature Profile of Infrared Reflow

120±30 s

(preheating)

180°C

120°C

(2) Wave soldering

• Temperature

260

C or below (molten solder temperature)

• Time

10 seconds or less

• Preheating conditions

120

C or below (package surface temperature)

• Number of times

One (Allowed to be dipped in solder including plastic mold portion.)

•

Flux

Rosin flux containing small amount of chlorine (The flux with a maximum chlorine

content of 0.2 Wt % is recommended.)

(3) Soldering by Soldering Iron

• Peak Temperature (lead part temperature) 350

C or below

• Time (each pins)

3 seconds or less

•

Flux

Rosin flux containing small amount of chlorine (The flux with a

maximum chlorine content of 0.2 Wt % is recommended.)

(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead

(4) Cautions

• Fluxes

Avoid removing the residual flux with freon-based and halogens-based (chlorine-based) cleaning solvent .

2. Cautions regarding noise

Be aware that when voltage is applied suddenly between the photocoupler’s input and output at startup, the output

transistor may enter the on state, even if the voltage is within the absolute maximum ratings.