11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

• The material deposited should always be even and wet. Lap each

stroke over the preceding stroke to obtain a uniform finish.

• To ensure the edges are covered, start spraying just to the side of the

area being sprayed and do not stop until the spray has gone past

the opposite edge.

• Damage to the needle or nozzle, or any of the air ports, will result in a

faulty spray pattern. Take care when cleaning or assembling these

components.

MAINTENANCE

It is essential that the spray gun is kept clean. Dried paint in the nozzle

assembly or airways will stop the gun from working. For the gun to perform at

its best it must be thoroughly cleaned after every use.

CLEANING PROCEDURE

1. After use, empty any remaining paint from the paint container, wipe the

container clean with a dry, lint free rag, and fill with thinner. Spray the

thinners through the spray gun until it is clean.

2. Residue from dirty solvent may clog the narrow air passages in the gun. Use

a cleaning brush and solvent to wash off accumulated paint.

3. Wipe down the outside of the gun with a solvent dampened cloth.

• DO NOT poke any of the holes in the air cap or nozzle with metal

instruments. These holes are precision drilled and can be damaged

by probing with anything harder than a wooden toothpick.

4. Make sure that the air inlet vent to the paint container is kept clean.

Blockages in this vent will prevent an even material flow through the gun.

• Component parts of spray guns are supplied in matched sets and

should only be used together.

• Do not overtighten components, and be careful not to cross thread

any parts on assembly.

• Never use silicon based lubricants as this may cause paint finish

defects.

5. Check the air supply hose regularly for any signs of damage and replace it

if necessary. Do not use damaged or leaking hoses.

• Finally, empty the spray gun and dry all components thoroughly.

Store in a clean, dry place.