6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

BEFORE USE

NOTE: Ensure the air supply is turned off.

1. If required, connect an in-line mini oiler to the tool.

• A mini oiler helps to prolong the life of the air tool.

2. If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the air inlet.

3. Connect a suitable hose to the female air inlet.

4. Connect the other end of the hose to the air supply.

5. Turn on the air supply and check for air leaks.

• Rectify any found before proceeding.

Your air tool is now ready for use.

You can fit a whip hose with a quick fit coupling if required (available from

your Clarke dealer.).

OPERATION

Before starting work, drain any water from the air tank and blow condensation

from the air line. Drain compressor more frequently in hot humid weather.

Note: item Nos refer to parts list, Page 10.

Ensure the correct nosepiece (item 1x) is installed for the size of the rivet

mandril being used, insert the mandril until the rivet buts snugly against the

nosepiece.

Insert the rivet into the workpiece to be secured, pressing firmly depress the

trigger. The riveter will ‘fire’, breaking off the mandril, allowing the riveter to be

removed from the workpiece and re-loaded. Spent mandrills will be ejected

from the rear of the riveter.

To change the nosepiece, unscrew and remove the installed nosepiece, a

slight spring resistance will be felt.

Choose the nosepiece to be installed, push firmly against spring resistance into

the head (item 2), screw home and tighten with the wrench supplied.

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND COMPRESSED AIR