UPC813

R03DS0149EJ0200 Rev.2.00

Page 2 of 7

Feb.25.25

ABSOLUTE MAXIMUM RATINGS (TA = 25 °C)

Parameter

Symbol

UPC813G2

Unit

Supply Voltage Note1

V+ - V-

-0.3 ~ +36

V

Differential Input Voltage

VID

±30

V

Input Voltage Note 2

VI

V- -0.3 ~ V+ +0.3

V

Output Applied Voltage Note3

VO

V- -0.3 ~ V+ +0.3

V

Total Power Dissipation Note4

PT

440

mW

Output Short Circuit Duration Note5

Indefinite

s

Operating Ambient Temperature

TA

-40 ~ +85

°C

Storage Temperature

Tstg

-55 ~ +125

°C

【

Note】 1. Note that reverse connections of the power supply may damage the ICs.

2. The input terminal must be applied within the input voltage range to avoid deteriorating or damaging the

device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The

Op-Amp input voltage must operates within the electrical characteristics range of input common-mode

voltage.

3. The output terminal must be applied within the output voltage range to avoid deteriorating or damaging the

device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The

Op-Amp output voltage must operates within the electrical characteristics range of maximum output voltage.

4. This is the value at TA ≤ +25 °C. De-rate value at -4.4 mW/°C when TA > 25 °C.

5. Please use the total loss and the de-rating value from Note 4.

RECOMMENDED OPERATING CONDITIONS

Parameter

Symbol

MIN.

TYP.

MAX.

Unit

Power Supply Voltage

V±

±5

±16

V

Load Current

IO

±10

mA

Load Capacitance (When AV = +1)

CL

220 Note6

pF

【

Note】 6. This is the value when the feedback resistor (Rf) = 0 Ω. The higher the Rf value, the more likely it is to oscillate

due to the influence of the input capacitance. So connect a capacitor of about 100 pF in parallel with Rf.

OFFSET ADJUSTMENT METHOD

【

Note】OFFSET NULL pin should be open or connected to V – via a resistor as shown above. Any connection

other than V – may cause malfunction, characteristics degradation or damage.

+

-

V -

5

1

6

2

3

10 kΩ

VR1