6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

setup is protected from passers by. Set the switch, at the rear of the pump to

ON (I).

Do not allow the pump to run dry for more than 30 seconds after pumping has

stopped.

MAINTENANCE

The pump requires no maintenance, but should be inspected before use to

ensure that the electric power cables and clamps are in good condition.

Ensure that the hoses used are perfectly sound.

Avoid using solvents if cleaning plastic parts, as most plastics are susceptible to

damage from various types of commercial solvents.

Store the pump in dry conditions protected from the weather.

For any problems requiring dismantling of the pump, contact your CLARKE

dealer.

SPECIFICATIONS

Please note that the details and specifications contained herein, are correct at the time

of going to print. However, CLARKE International reserve the right to change

specifications at any time without prior notice. Always consult the pump’s data plate.

Fluid Classification / Fluids to be used

Clean (motor oil, diesel)

Max. Head

0.7 m

Max. Flowrate (dependant upon

temperature/type of oil)

1.5 litres/min (diesel)

0.2 litres/min (engine oil)

Max Operating Time

30 mins

Max. Temperature of liquid being pumped

60o C (Oil) / 45o C (Diesel)

Self Priming

Yes

Weight

0.85 kg

Inlet Hose Length

1.2 m

Outlet Hose Length

1.6 m

Motor

12V DC / 9.4 A

IP Rating

IPx4