DN1102W datasheet(8/10 Pages) ETC2

Il numero della parte	DN1102W

Spiegazioni elettronici	Surface Mount IRED

PDF	10 Pages

Scroll/Zoom	100%

Produttore elettronici	ETC2 [List of Unclassifed Manufacturers]

Homepage

Logo

8 / 10 page

DN1102W

Page 8

Surface Mount IRED/Inner Lens Type

Reflow Soldering Conditions

Manual Soldering Conditions

Iron tip temp.

Soldering time and frequency

3 s

1 time

350 ℃

(MAX.)

(MAX.) (30 W Max.)

1) The above profile temperature gives the maximum temperature of the LED resin surface.

Please set the temperature so as to avoid exceeding this range.

2) Total times of reflow soldering process shall be no more than 2 times.

When the second reflow soldering process is performed, intervals between the first

and second reflow should be short as possible (while allowing some time for the

component to return to normal temperature after the first reflow) in order to prevent the

LED from absorbing moisture.

3) Temperature fluctuation to the LED during the pre-heating process shall be minimized.

2007.8.31

DN1102W Scheda tecnica(PDF) 8 Page - List of Unclassifed Manufacturers