8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

OPERATION

FITTING THE SANDING SHEET

1. With the sander disconnected from the power supply, select the sanding

sheet appropriate for the task and attach it to the base plate as follows.

Either plain sanding sheets or prepared sheets for hook and loop

attachment can be used.

PLAIN SANDING SHEETS

1. Lift the paper retaining clips to the

open position and insert one end

of the sanding sheet under the

retaining clip. Set the clip back in

the retaining position to hold the

sheet and lightly stretch it over the

baseplate, ensuring it is not folded

or wrinkled, then position it under

the other retaining clip. Lock the

second clip back into the

retaining position.

2. Check the sheet lays straight and

flat on the baseplate. If not,

release either clip and adjust the

sheet before resetting the clip.

HOOK AND LOOP SANDING SHEETS

1. Align the sanding sheet so that

the holes are aligned with those in

the base plate (this is necessary

for dust extraction), press the

sheet evenly onto the base plate

to attach it.

REPLACEMENT SHEETS

The following sanding sheets are available from your CLARKE dealer.

Grit

Size (mm)

Part No

60

115 x 230 mm

6502072

80

115 x 230 mm

6502073

120

115 x 230 mm

6502074