11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE AND SERVICING

GENERAL MAINTENANCE

1. Check that the power cable is free from cracks, bare wires etc. Avoid using

solvents when cleaning plastic parts. Most plastics are susceptible to damage from

solvents.

2. Ensure all screws remain tight to ensure the jigsaw is in safe working condition.

• All bearings etc, in this machine are lubricated with a sufficient amount of

high grade lubricant for the tools lifetime under normal operating

conditions, therefore no further lubrication is required.

• Only use the replacement blades specified for this product available from

your CLARKE dealer.

3. After use, clean all dust and wood dust from the saw. To ensure constant air

circulation, always keep air vents clear of blockages, (use compressed air to clean

the machine if possible. (Wear PPE when using compressed air).

4. Keep the sole plate free from dirt and grime. Regularly clean to prevent scratches

and scores on the surface.

5. Resin and glue on the blade causes poor cutting results. If necessary clean the

blade after use.

6. Refer to your CLARKE dealer if internal maintenance is required.

REPLACEMENT BLADES

Replacement blades are available from your CLARKE dealer as follows:

Wood - 6462196 (pack of 5)

Metal - 6462198 (pack of 5)

WARNING: BEFORE PERFORMING ANY MAINTENANCE TASKS

ENSURE THE PLUG HAS BEEN REMOVED FROM THE MAINS SUPPLY.