8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

•

The tab initially lays flat against the long beam.

7. Next, bend the tab back through 180 degrees to grip the long beam.

•

Use a screwdriver or similar tool to bend the tabs.

8. Finally bend the tab again through 90 degrees the opposite way, to seat

tightly against the support beam.

9. Ensure there is no movement between the beams.

10. Lay the shelf panels into position.

•

Always assemble the top shelf at the highest posible position.

11. Fit the plastic end caps to the end of each post.