5

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

6. DO NOT weld on coated metals such as galvanized, lead, or cadmium plated

steel, unless the coating is removed from the weld area, the area is well

ventilated, and while wearing an air-supplied respirator. The coatings and any

metals containing these elements can give off toxic fumes if welded.

7. Respirator misuse can be hazardous. Welding produces fumes and gases.

Breathing these fumes and gases can be hazardous to your health.

8. Read and follow these instructions and the safety labels carefully. The powered air

purifying respirator (PAPR) helps protect the user from specific airborne

contaminants but must be used correctly to be fully effective. Have an industrial

hygienist test the air in your facility to ensure the PAPR provides adequate

protection from contaminants in your environment. If you have questions about

the respirator, see equipment warning label and consult your Safety Director and a

certified Industrial Hygienist.

9. Follow all applicable EN/ANSI/CSA/AS & NZS and other regulatory guidelines

pertaining to the use of respirators.

10. DO NOT use the powered air purifying respirator where there is danger of fire of

explosion.

11. DO NOT use the powered air purifying respirator in windy conditions or negative

pressure inside the hood may draw in contaminants from the outside air.

12. DO NOT use the powered air purifying respirator without a properly installed

spark guard cover.

13. Without the spark guard cover, welding sparks may ignite the filter or damage the

filters and allow unfiltered air into the helmet.

14. The powered air purifying respirator does not supply oxygen. Use the respirator

only in atmospheres for which it is EN/ANSI/CSA/AS&NZS approved. DO NOT use

the respirator where oxygen levels are 19.5% or lower, where contaminant levels

are unknown or are immediately dangerous to life or health, or where the

contaminant levels exceed the respirator specifications.

15. DO NOT enter a hazardous area until you are sure the respirator equipment is

correctly assembled, working properly, and properly worn.

16. Before each use, inspect the respirator equipment for damage and verify it

operates properly,

17. Before using the respirator, test air flow to verify it is providing an adequate

volume of air.

18. DO NOT use the powered air purifying respirator without all filter components or

with the blower turned off hazardous levels of oxygen and carbon dioxide may

accumulate in helmet.

19. ALWAYS wear the powered air purifying respirator when entering a

contaminated area. Do not remove the respirator until outside the contaminated

area.