AX-496/396

IMPEDANCE SELECTOR

WARNING:

Do not change the IMPEDANCE SELECTOR

switch setting while the power to this unit is

on, otherwise this unit may be damaged.

2

TAPE

STANDBY/ON

DECK A/B

DIR B

DIR A

A/B/C/D/E

PRESET

CD/DVD

MD

TAPE

TUNER

AUX

RAX9

V499920

PHONO

–+

CD

TUNER

DISC SKIP

–+

VOLUME

WALL

OUTLET

EQUIPMENT

UNDER TEST

AC LEAKAGE

TESTER OR

EQUIVALENT

INSULATING

TABLE

WARNING: CHEMICAL CONTENT NOTICE!

The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and /or plastic

(where applicable) components may also contain traces of chemicals found by the California Health and Welfare Agency

(and possibly other entities) to cause cancer and/or birth defects or other reproductive harm.

DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REA-

SON WHATSOEVER!

Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose

eyes to solder/flux vapor!

If you come in contact with solder or components located inside the enclosure of this product, wash your hands before

handling food.

I TO SERVICE PERSONNEL

1. Critical Components Information.

Components having special characteristics are marked s

and must be replaced with parts having specifications equal

to those originally installed.

2. Leakage Current Measurement (For 120V Models Only).

When service has been completed, it is imperative to verify

that all exposed conductive surfaces are properly insulated

from supply circuits.

G Meter impedance should be equivalent to 1500 ohm shunted

by 0.15

µF.

G Leakage current must not exceed 0.5mA.

G Be sure to test for leakage with the AC plug in both polarities.

I REMOTE CONTROL PANEL

I IMPEDANCE SELECTOR