4

Raspberry Pi AI HAT+ – Raspberry Pi Ltd

Physical specification

2.55

14.5

16.5

Note:

All dimensions in mm

All dimensions are approximate and for

reference purposes only. The dimensions

shown should not be used for producing

production data

The dimensions are subject to part and

manufacturing tolerances

Dimensions may be subject to change

47.5

7.5

10

49

16

56.5

17.5

21

3.5

3.5

18

65

58

29

5

17

17

WARNINGS

•

The Raspberry Pi AI HAT+ shall only be connected to a Raspberry Pi via the PCIe interface and GPIO header.

•

This product should be operated in a well-ventilated environment, and if used inside a case, the case should not be

covered.

•

Whilst in use, this product should be firmly secured, and should not be contacted by conductive items.

•

All peripherals used with this product should comply with relevant standards for the country of use and be marked

accordingly to ensure that safety and performance requirements are met.

•

The cables and connectors of all peripherals used with this product must have adequate insulation so that relevant

safety requirements are met.

•

Operation of this device requires adult supervision.

SAFETY INSTRUCTIONS

To avoid malfunction or damage to this product, please observe the following:

•

Do not expose to water or moisture, or place on a conductive surface whilst in operation.

•

Do not expose to heat from any source; Raspberry Pi computers and the Raspberry Pi AI HAT+ are designed for

reliable operation at normal ambient temperatures.

•

Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.

•

Whilst it is powered, avoid handling the printed circuit board, or only handle it by the corners to minimise the risk of

electrostatic discharge damage.