U.I. Lapp

GmbH

DATA SHEET

ÖLFLEX® EB CY

DB 0012640

valid from: 2015-02-11

Originator:

KASC / PDC

approved:

HAPF / PDC

Document:

DB0012640EN

Page 1 of 1

All deviations from this specification are subject to explicit consent of U.I. Lapp GmbH. All rights reserved acc. to DIN 34.

PD 0019/2.1_11.09EN

Application

ÖLFLEX

® EB CY are PVC control cables with blue outer sheath for occasional flexible use and fixed installation in intrinsically

safe circuits. They are among others designed for use in dry, damp and wet rooms. Outdoor use: They may only be installed

with UV protection and considering the temperature range. At room temperature they are widely resistant to certain oils and

resistant to acids. They are suitable for non-continuously recurring movement without tensile load. Continuous operation

movement, compulsory guidance respectively usage on cable drums or pulleys or under a tensile strain of more than 15 N /

mm² conductor cross section are not allowed.

Application range:

Installation of intrinsically safe circuits, where a special cable marking for hazard area type “ i “ – intrinsic safety is specified;

The cables meet the requirements of DIN EN 60079-14(VDE 0165-1):2012-2 potentially explosive atmosphere. The screen is

a protection against electrical interference.

Design

Design

based on

DIN EN 50525-2-51 resp. VDE 0285-525-2-51

Conductor

fine wire strands of bare copper acc. to IEC 60228 resp. VDE 0295, Class 5

Core insulation

LAPP special PVC compound P8/1

PVC compound TI2 acc. to DIN EN 50363-3 resp. VDE 0207-363-3 with increased

Requirements acc. to Lapp specification

Core identification

acc. to VDE 0293-1, with or without GN/YE ground conductor

black cores with white numbers acc. to DIN EN 50334 resp. VDE 0293-334

Wrapping

plastic foil

Screen

braid of tinned copper, coverage = 85% (nominal value)

Outer sheath

PVC compound TM2 acc. to DIN EN 50363-4-1 resp. VDE 0207-363-4-1

with increased requirements acc. to Lapp specification

colour: blue, similar RAL 5015.

Electrical properties

Nominal voltage

300 / 500 V

Operating Voltage

< 50 V AC resp. < 75 V DC in intrinsically safe circuits

Test voltage

Core/Core:

3000 V AC

Core/Screen:

2000 V AC

Mechanical and thermal properties

Min. bending radius

occasional flexing:

20 x outer diameter

fixed installation:

6 x outer diameter

Temperature range

occasional flexing:

-5 °C up to +70 °C max. conductor temp.

fixed installation:

-40 °C up to +80 °C max. conductor temp.

Flammability

flame retardant in acc. to IEC 60332-1-2 resp. VDE 0482-332-1-2

Tests

acc. to IEC 60811 resp. VDE 0473-811, VDE 0472, EN 50395, EN 50396

EC-Directives

This cable is conform to the EC-Directives 2006/95/EC (Low Voltage Directive)

and 2011/65/EU (RoHS, Restriction of the use of certain hazardous substances).