LMX1602 datasheet(15/17 Pages) NSC

Il numero della parte	LMX1602

Spiegazioni elettronici	PLLatinum??Low Cost Dual Frequency Synthesizer

PDF	17 Pages

Scroll/Zoom	100%

Produttore elettronici	NSC [National Semiconductor (TI)]

Homepage	http://www.national.com

Logo

15 / 17 page

2.0 Programming Description (Continued)

2.7

TYPICAL APPLICATION EXAMPLE

10012920

OPERATIONAL NOTES:

VCO is assumed AC coupled.

IN increases impedance so that VCO output power is provided to the load rather than the PLL. Typical values are 10

Ω to

200

Ω depending on the VCO power level. The fin RF impedance ranges from 40Ω to 100Ω. The fin IF impedances are higher.

*** 50

Ω termination is often used on test boards to allow use of external reference oscillator. For most typical products, a CMOS

clock is used and no terminating resistor is required. OSC

IN may be AC or DC coupled. AC coupling is recommended because

the input circuit provides its own bias. (See Figure below)

10012921

**** Adding RC filter to the V

CC line is recommended to reduce loop-to-loop noise coupling.

— Proper use of grounds and bypass capacitors is essential to achieve a high level of performance. Crosstalk between pins can

be reduced by careful board layout.

— This is a static sensitive device. It should be handled only at static free work stations.

LMX1602 Scheda tecnica(PDF) 15 Page - National Semiconductor (TI)