AT90USB82 datasheet(15/306 Pages) ATMEL

15 / 306 page

7707D–AVR–07/08

AT90USB82/162

4.8.1

Interrupt Response Time

The interrupt execution response for all the enabled AVR interrupts is five clock cycles minimum.

After five clock cycles the program vector address for the actual interrupt handling routine is exe-

cuted. During these five clock cycle period, the Program Counter is pushed onto the Stack. The

vector is normally a jump to the interrupt routine, and this jump takes three clock cycles. If an

interrupt occurs during execution of a multi-cycle instruction, this instruction is completed before

the interrupt is served. If an interrupt occurs when the MCU is in sleep mode, the interrupt exe-

cution response time is increased by five clock cycles. This increase comes in addition to the

start-up time from the selected sleep mode.

A return from an interrupt handling routine takes three clock cycles. During these three clock

cycles, the Program Counter (three bytes) is popped back from the Stack, the Stack Pointer is

incremented by three, and the I-bit in SREG is set.

Assembly Code Example

sei

; set Global Interrupt Enable

sleep

; enter sleep, waiting for interrupt

; note: will enter sleep before any pending

; interrupt(s)

C Code Example

__enable_interrupt(); /* set Global Interrupt Enable */

__sleep(); /* enter sleep, waiting for interrupt */

/* note: will enter sleep before any pending interrupt(s) */

AT90USB82 Scheda tecnica(PDF) 15 Page - ATMEL Corporation