PM6675ASTR datasheet(33/48 Pages) STMICROELECTRONICS

Il numero della parte	PM6675ASTR

Spiegazioni elettronici	High efficiency step-down controller with embedded 2 A LDO regulator

PDF	48 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

33 / 48 page

PM6675AS

Device description

33/48

Figure 36.

LDO current limit setting

7.2.2

LDO section soft-start

The LDO section soft-start is performed by clamping the current limit. During startup, the

LDO current limit voltage is set to 1 A and the output voltage increases linearly. When the

output voltage rises above 90 % of the nominal value, the current limit is released to 2 A

according to the LILIM pin setting.

7.2.3

LDO section power-good signal

The LPG pin is an open drain output used to monitor the LDO output voltage through LFB

pin. The LPG signal is held low if the output voltage drops 10 % below or rises 10 % above

the nominal regulated value. The LPG output can sink current up to 4 mA.

7.2.4

LDO section output discharge

Active soft-end of the LDO output occurs when the LEN (Linear ENable) is forced low. When

the LDO section is turned off, an internal 25

Ω resistor, directly connected to the LOUT pin,

discharges the output.

Figure 37.

LDO section soft-end

0.0

0.2

0.4

0.6

0.8

1.0

1.2

1.4

1.6

1.8

2.0

2.2

0.0

0.5

1.0

1.5

2.0

2.5

3.0

3.5

4.0

4.5

5.0

VLIN [V]

VOUT=1.05V

VOUT=1.2V

VOUT=1.5V

VOUT=1.8V

VOUT=2.0V

VOUT=2.2V

VOUT=2.5V

VOUT=3.3V

LEN

VLDO

Resistive Discharge

PM6675ASTR Scheda tecnica(PDF) 33 Page - STMicroelectronics

PM6675ASTR Scheda tecnica(HTML) 33 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Scheda tecnica Scarica

Link URL