STW4141 datasheet(19/31 Pages) STMICROELECTRONICS

19 / 31 page

Functional description

STw4141

18/30

Functional description

Introduction

The STw4141 is an easy to use, single coil dual outputs step down DC/DC converter

optimized to supply low-voltage to CPUs or DSPs in cell phones and other miniature devices

output voltages with high efficiency operation in a wide range of output currents. The device

offers high DC voltage regulation accuracy and load transient response to satisfy

demanding processor core supply. The converter is based on voltage mode buck

architecture using PWM and PFM operation modes.

At light load currents, the device can operate in PFM mode to maintain high efficiency over

the entire load current range. Switching between PWM and PFM modes can be done

automatically or can be forced by external pins (AUTO and MODE/SYNC). Externally

synchronized or fixed frequency (internal oscillator) PWM mode offers full output current

capability while minimizing interference to sensitive RF and data acquisition circuits.

PWM and PFM mode operation

PWM (Pulse Width Modulation) mode is intended for normal load to high load currents.

Energy is delivered to the load with an accurate and defined frequency of 900 kHz.

PFM (Pulse Frequency Modulation) mode is intended for low load currents to maintain high

efficiency conversion.

Forced mode: When AUTO pin is LOW, the operating mode is selectable by the user itself.

It means that system controls the behavior of the STw4141 according to processor needs.

STw4141 is switched from PWM to PFM mode using MODE/SYNC pin (refer to

Section 4.1).

Automatic PWM / PFM switch: When AUTO pin is HIGH, the operating mode is directly

controlled by internal digital circuit according to processor needs. The device switches from

PWM to PFM by itself if sum of output currents is lower than approximately 100 mA during at

least 16 clock cycles. The device can be forced to PWM mode connecting MODE/SYNC to

HIGH level. (see

Section 2.8 and Section 2.9).

Current limiter

This protection limits the current flowing through coil. As soon as ILIM is detected, the duty

cycle is terminated and prevents the coil current against rising above peak current limit.

There is no reset of device.

Short circuit protection

It protects the device against short-circuit at output terminals. When one or both output

voltages are decreased by 0.7 V below their nominal output values the device enters into

reset followed by soft start sequence.

Thermal shutdown protection

Thermal shutdown protects the device against damage due to overheating when maximum

operating junction temperature is exceeded. The device is kept in reset until junction

temperature decreases by 25°C approximately.

STW4141 Scheda tecnica(PDF) 19 Page - STMicroelectronics

STW4141 Scheda tecnica(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Scheda tecnica Scarica

Link URL