HD6433636SW datasheet(185/418 Pages) RENESAS

185 / 418 page

171

upper 8 bits and OCRFL as the lower 8 bits of the register, or OCRFH and OCRFL can be used as

independent 8-bit registers.

OCRFH and OCRFL can be read and written by the CPU, but in 16-bit mode, data transfer with

the CPU takes place via a temporary register (TEMP). For details see 9.3.3, Interface with the

CPU.

Upon reset, OCRFH and OCRFL are each initialized to H'FF.

16-Bit Mode (OCRF): 16-bit mode is selected by clearing bit CKSH2 to 0 in timer control

When the contents match, the compare match flag (CMFH) in TCSRF is set to 1. Also, IRRTFH

in interrupt request register 2 (IRR2) is set to 1. If bit IENTFH in interrupt enable register 2

(IENR2) is set to 1, a CPU interrupt is requested.

Output for pin TMOFH can be toggled by compare match. The output level can also be set to high

or low by bit TOLH of timer control register F (TCRF).

8-Bit Mode (OCRFH, OCRFL): Setting bit CKSH2 in TCRF to 1 results in two 8-bit

independent registers, OCRFH and OCRFL.

The OCRFH contents are always compared with TCFH, and the OCRFL contents are always

compared with TCFL. When the contents match, the compare match flag (CMFH or CMFL) in

TCSRF is set to 1. Also, bit IRRTFH (IRRTFL) in interrupt request register 2 (IRR2) set to 1. If

bit IENTFH (IENTFL) in interrupt enable register 2 (IENR2) is set to 1 at this time, a CPU

interrupt is requested.

The output at pin TMOFH (TMOFL) can be toggled by compare match. The output level can also

be set to high or low by bit TOLH (TOLL) of the timer control register (TCRF).

HD6433636SW Scheda tecnica(PDF) 185 Page - Renesas Technology Corp