INSULATOR

4-40 C'SINK SCREW

WITH 0.25 LONG (4X)

6-32 PAN HEAD SCREW

WITH WASHER

0.25 LONG (4X)

COVER

CHASSIS

Rev. 09.04.07

TLP150CJ Enclosure

1 of 2

Embedded Power for

Business-Critical Continuity

TLP150CJ

Enclosure

Installation Notes

TLP150CJ • Cover Accessory Kit

TLP150CJ will fit the TLP150 power supplies.

Materials

1 Base

1 Cover

4 M3X6mm Pan head screws

with spring washer

4 M3X6mm countersunk

screws

1 M4 nut

1 M4 star washer

1 M4 spring washer

1 Plastic insulator sheet

Installation Instructions and Notes

1. Place the insulator over the chassis as shown.

2. Place TLP150 power supply over the insulator as shown.

3. Align the 4x power supply to the chassis standoff.

4. Secure 4 pan head screws with washer provided with in kit as shown.

5. Place the cover over TLP150 power supply as shown.

6. Align the 4x cover to the U-bracket countersink holes.

7. Secure 4 countersink screws provided with in kit as shown.

8. Overall dimensions: 5.95 (151.13) x 3.4 (86.36) x 1.6 (40.64).

9. Base plate has two sets of customer mountings:

a. Bottom mounting (4X) M3 inserts. Max. screw penetration 0.0787 (2mm)

b. Side mounting (4X) M3 inserts. Max. screw penetration 0.236 (6mm)

10. Ensure insulator is correctly fitted in base under PCB to maintain safety creepage

and clearances.

11. Ensure base is firmly connected to supply earth via the earth stud marked

12. When using this enclosure, ensure that relevant safety standards (e.g. EN60950) are com-

plied with, in respect to creepage and clearance distances, and distances through insulation.

13. All dimensions are in inches (mm)