NECHIP datasheet(64/77 Pages) ETC2

Il numero della parte	nechip

Spiegazioni elettronici	Serial to ethernet,ethernet to serial module,Serial to IP,RS232 interface/USER MANUAL

PDF	77 Pages

Scroll/Zoom	100%

Produttore elettronici	ETC2 [List of Unclassifed Manufacturers]

Homepage

Logo

64 / 77 page

CONEXTOP NEPORT User Manual

Chapter 6 AT Command

6-1

Chapter 6 AT Command

AT command is a set of communication protocols between a host computer and devices. AT

originated in the word "Attention", it was first used for communication between terminal and

modem, and then latter gradually evolved into industry standards for communications equipment.

NEPORT series products expands it, support the use of AT commands to configure device

parameters and network connectivity and so on.

6.1 AT commands for parameters setting

Please refer to the CONEXTOP NEPORT AT commands to get the detail description of AT

commands.

6.1.1 Basic Settings

command

contents

AT!BC

WEB and TELENT console switch

AT!BDN

Set the name of device

AT!BTS

Set time related parameters.

Table 6-1 AT commands for basic settings

6.1.2 Network

command

contents

AT!EC

Ethernet settings

AT!IC

IP address obtain methods settings

AT!AIC

Automatically obtain IP address settings

Table 6-2 AT commands for network

6.1.3 PPPoE

command

contents

AT!PC

PPPoE dial-up settings

AT!PS

PPPoE status query

Table 6-3 AT commands for PPPoE

nechip Scheda tecnica(PDF) 64 Page - List of Unclassifed Manufacturers