24LCS22AT datasheet(12/26 Pages) MICROCHIP

12 / 26 page

24LCS22A

DS21682E-page 12

6.0

WRITE PROTECTION

When using the 24LCS22A in the Bidirectional mode,

the VCLK pin can be used as a write-protect control

pin. Setting VCLK high allows normal write operations,

while setting VCLK low prevents writing to any location

in the array. Connecting the VCLK pin to VSS would

allow the 24LCS22A to operate as a serial ROM,

although this configuration would prevent using the

device in the Transmit-Only mode.

Additionally, pin 3 performs a flexible write-protect

function. The 24LCS22A contains a write protection

control fuse whose factory default state is cleared.

Writing any data to address 7Fh (normally the

checksum in DDC applications) sets the fuse which

enables the WP pin. Until this fuse is set, the

24LCS22A is always write enabled (if VCLK = 1). After

the fuse is set, the write capability of the 24LCS22A is

determined by both VCLK and WP pins (Table 6-1).

TABLE 6-1:

WRITE-PROTECT TRUTH

TABLE

7.0

READ OPERATION

Read operations are initiated in the same way as write

operations with the exception that the R/W bit of the

slave address is set to one. There are three basic types

of read operations: current address read, random read

and sequential read.

7.1

Current Address Read

The 24LCS22A contains an address counter that

maintains the address of the last word accessed,

internally incremented by one. Therefore, if the

previous access (either a read or write operation) was

to address n, the next current address read operation

would access data from address n + 1. Upon receipt of

the slave address with R/W bit set to one, the

24LCS22A issues an acknowledge and transmits the

eight bit data word. The master will not acknowledge

the transfer, but does generate a Stop condition and the

24LCS22A discontinues transmission (Figure 7-1).

FIGURE 7-1:

CURRENT ADDRESS

READ

7.2

Random Read

Random read operations allow the master to access

any memory location in a random manner. To perform

this type of read operation, first the word address must

be set. This is done by sending the word address to the

24LCS22A as part of a write operation. After the word

address is sent, the master generates a Start condition

following the acknowledge. This terminates the write

operation, but not before the internal Address Pointer is

set. Then the master issues the control byte again but

with the R/W bit set to a one. The 24LCS22A will then

issue an acknowledge and transmits the 8-bit data

word. The master will not acknowledge the transfer, but

does generate a Stop condition and the 24LCS22A

discontinues transmission (Figure 7-2).

VCLK

Address

7Fh Written

Mode

for

00h-7Fh

Read-only

R/W

1/open

R/W

Yes

Read-only

Control

Byte

Data n

Bus Activity

SDA Line

Bus Activity

Master

101 000 0 1

24LCS22AT Scheda tecnica(PDF) 12 Page - Microchip Technology

24LCS22AT Scheda tecnica(HTML) 12 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Scheda tecnica Scarica

Link URL