6 / 10 page
Preliminary
4-204
RF2416
Rev A2 010810
4
Application Notes
Bypass Mode Configurations
The RF2416 may be placed into either high gain or bypass mode via the HB SELECT and LB SELECT pins for high
band and low band operation, respectively. The high gain state is selected by asserting the select pin for the appropriate
band to a voltage level of less than 0.8V. For Bypass operation, there are two possible methods for placing the RF2416
into this low gain state. The table below shows the two possible Bypass states for each mode.
RF2416 Bypass Mode Possibilities
For both Bypass configurations, the select pin for the appropriate band must be placed at a level greater than or equal to
1.8 V. The difference between the Bypass possibilities is determined by the specific application’s ability to change the
voltage of the bias pins independently of VCC. The advantage of the ability to assert the bias pins to 0V when in Bypass
mode is shown by the decreased current draw when in this Bypass configuration.
Gain Select
(HB Mode)
HB BIAS (V)
VCC1_HB and
VCC2_HB (V)
Current (mA)
2.7
0
2.78
1.4
2.7
2.7
2.78
1.9
Gain Select
(LB Mode)
LB BIAS (V)
VCC1_LB (V)
Current (mA)
2.7
0
2.78
0.8
2.7
2.7
2.78
1.5
Italian ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
