WLCSP16 datasheet(11/38 Pages) NXP

11 / 38 page

LPC1102

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 00 — 23 June 2010

11 of 38

NXP Semiconductors

LPC1102

32-bit ARM Cortex-M0 microcontroller

• Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.

• Flag to indicate watchdog reset.

• Programmable 32-bit timer with internal prescaler.

• Selectable time period from (Tcy(WDCLK) × 256 × 4) to (Tcy(WDCLK) × 232 × 4) in

multiples of Tcy(WDCLK) × 4.

• The Watchdog Clock (WDCLK) source can be selected from the Internal RC oscillator

(IRC), the Watchdog oscillator, or the main clock. This gives a wide range of potential

timing choices of Watchdog operation under different power reduction conditions. It

also provides the ability to run the WDT from an entirely internal source that is not

dependent on an external crystal and its associated components and wiring for

increased reliability.

7.14 Clocking and power control

7.14.1 Crystal oscillators

The LPC1102 include two independent oscillators. These are the Internal RC oscillator

(IRC) and the Watchdog oscillator. Each oscillator can be used for more than one purpose

as required in a particular application.

Following reset, the LPC1102 will operate from the Internal RC oscillator until switched by

software. This allows systems to operate without any external crystal and the bootloader

code to operate at a known frequency.

See Figure 4 for an overview of the LPC1102 clock generation.

WLCSP16 Scheda tecnica(PDF) 11 Page - NXP Semiconductors