7.3

Default Jumper Settings and Switch Positions

8

ADS1246EVM-PDK Kit Operation

ADS1246EVM-PDK Kit Operation

www.ti.com

Figure 3 shows the jumpers found on the EVM and the respective factory default conditions for each.

Figure 3. ADS1246EVM Default Jumper Locations

Table 6 lists the switches found on the EVM and the respective factory default conditions for each.

Table 6. List of Switches

Switch

Default Position

Switch Description

S1

Left

Onboard reference

This section provides information on using the ADS1246EVM-PDK, including setup, program installation,

and program usage.

To prepare to evaluate the ADS1246 with the ADS1246EVM-PDK, complete the following steps:

Step 1.

Install the ADCPro software (if not already installed) on a PC.

Step 2.

Install the ADS1246EVM-PDK EVM plug-in software.

Step 3.

Complete the USB driver installation process.

Step 4.

Set up the ADS1246EVM-PDK.

Step 5.

Connect the ADS1246EVM-PDK to the computer with a USB cable.

Step 6.

Run the ADCPro software.

Each task is described in the subsequent sections of this document.

8

ADS1146EVM, ADS1246EVM, ADS1146EVM-PDK, ADS1246EVM-PDK

SBAU149A – June 2009 – Revised July 2009

Submit Documentation Feedback