705-5100-F21 datasheet(10/52 Pages) MAGNETROL

10 / 52 page

57-645 Eclipse Guided Wave Radar Transmitter - PROFIBUS PA™

2.4

QuickStart Configuration

The Eclipse transmitter comes partially configured from

the factory but can be reconfigured in the shop (disregard

fault message due to unattached probe). The minimum

configuration instructions required in the field follow. Use

the information from the operating parameters table in

Section 2.1.2 before beginning configuration.

1. Power up the transmitter.

The display changes every 5 seconds to show one of two

values: Status & Level.

2. Remove the cover of the lower electronic compartment.

3. Use the Up or Down Arrow (

) keys to move from one

step of the configuration program to the next step.

4. Press the Enter Arrow (

) key. The last

character in the first line of the display

changes to an exclamation point (!).

5. Use the Up or Down Arrow (

) keys to increase or

decrease the value in the display or to scroll through the

choices.

6. Press the Enter Arrow (

) key to accept a value and move

to the next step of the configuration program (the default

password is 0).

7. After entering the last value, allow 10 seconds before

removing power from the transmitter.

The following configuration entries are the minimum required for

configuration (the default password is 0 from the LCD/keypad).

PrbModel

xxx

PrbModel

(select)

Probe Ln

xxx.x

LvlOfst

xxx.x

Dielctrc

(select)

Select the Probe Model to be used

Model 705: 7xA-x, 7xB-x, 7xD-x, 7xE-x, 7xF-F, 7xF-P,

7xF-4, 7xF-x, 7xJ-x, 7xK-x, 7xP-x, 7xR-x, 7xS-x,

7xT-x, 7x1-x, 7x2-x, 7x5-x, 7x7-x

Select the type of Probe Mounting to vessel (NPT, BSP, or

flange).

Select from Level Only, Level and Volume, Interface Level

or Interface Level and Volume.

Enter the exact Probe Length as printed on the probe

nameplate.

Enter the Level Offset value. Refer to Section 2.6.6 for

further information. (The unit is shipped from the factory

with offset = 0; i.e., all measurements are referenced to

the bottom of the probe).

Enter the Dielectric range for the material to be measured.

Level Offset

Probe Length

Probe Mount

Probe Model

Dielectric

of Medium

{

}

PrbMount

(select)

Enter

Down

MeasType

(select)

705-5100-F21 Scheda tecnica(PDF) 10 Page - Magnetrol International, Inc.

705-5100-F21 Scheda tecnica(HTML) 10 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Scheda tecnica Scarica

Link URL