SLA24C01-SSLASHP datasheet(13/27 Pages) SIEMENS

Il numero della parte	SLA24C01-S/P

Spiegazioni elettronici	1/2 Kbit 128/256 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus

PDF	27 Pages

Scroll/Zoom	100%

Produttore elettronici	SIEMENS [Siemens Semiconductor Group]

Homepage	http://www.siemens.com/

Logo

13 / 27 page

SLx 24C01/02/P

Semiconductor Group

1998-07-27

5.3

Acknowledge Polling

During the erase/write cycle the EEPROM will not respond to a new command byte until

the internal write procedure is completed. At the end of active programming the chip

returns to the standby mode and the last entered EEPROM byte remains addressed by

the address counter. To determine the end of the internal erase/write cycle acknowledge

polling can be initiated by the master by sending a START condition followed by a

command byte CSR or CSW (read with b0 = 1 or write with b0 = 0). If the internal erase/

write cycle is not completed, the device will not acknowledge the transmission. If the

internal erase/write cycle is completed, the device acknowledges the received command

byte and the protocol activities can continue.

Figure 9

Flow Chart “Acknowledge Polling”

Internal Programming

Procedure

Send Start

Send CS-Byte

from EEPROM

Acknowledge

received?

Next Operation

Yes

IED02131

SLA24C01-S/P Scheda tecnica(PDF) 13 Page - Siemens Semiconductor Group