Hand Tool for Disk Drive Power Connection System Crimp Terminals

Doc No: ATS-638117000

Release Date: 01-19-07

UNCONTROLLED COPY

Page 3 of 6

Revision: B

Revision Date: 03-29-08

Note:

A crimp height chart is provided with this manual as Reference Only.

Due to the wide range of wires, strands, insulation diameters, and

durometers, actual crimp height measurements may very slightly. An

occasional, destructive, pull force test should be preformed to check

hand tool crimp. Pull Force value Must exceed the Minimum pull force

specifications listed on page 2.

Locator Replacement

See the parts list on the last page of this document for the proper locator

order number. Follow the steps below to replace the locator.

1. Open the crimp hand tool.

2. Swing the existing locator open and away from the hand

tool.

3. Firmly press down on the brass pivot shaft with your

thumb, while pulling the locator up. Slip the locator off the

top of the brass pivot shaft. See Figure 4.

4. Replace it with the desired locator by putting over the brass

pivot shaft and snapping it into place.

SWING

LOCATOR

OPEN

PRESS DOWN

ON BRASS

PIVOT SHAFT

LIFT UP LOCATOR

JAWS

OPEN

Figure 4

TERMINAL

PUSH HERE

TO OPEN

WIRE STOP

SWING OPEN

LOCATOR

LOCATOR

TERMINAL

IN PLACE

Figure 2

LOCATOR

IN PLACE

WIRE STOP

TERMINAL

WIRE AGAINST

STOP

Figure 3

WIRE STOP

WIRE