RS-232 connection on

34401A

www.ti.com

Starter System Setup

Figure 18 shows connection to the serial port of the DMM for communication. This connection is used in

order to have remote control of the instrument. The other end of the cable is connected to the serial port

on your computer. In order to use this capability, you must set the DMM to RS-232 mode. An optional way

to communicate with the DMM is via the IEEE488 card.

Figure 18. Connect Serial Port to DMM

19

SBOU087A

– August 2010 – Revised April 2011

Multi-Cal-System Evaluation Module

Submit Documentation Feedback

Copyright

© 2010–2011, Texas Instruments Incorporated