AD6630PCB datasheet(3/8 Pages) AD

3 / 8 page

–3–

REV. 0

AD6630

Test

Parameter

Temp

Level

Min

Typ

Max

Units

HIGH LEVEL CLAMP MAXIMUM OUTPUT @ 250 MHz

4, 5

Full

11.2

12.2

dBm

PHASE VARIATION6

+25

°C

Degree

CMRR7

+25

°CV

PSRR

+25

°CV

NOTES

1All specifications are valid across the operating frequency range when the source and load impedance are a conjugate match to the amplifier’s input and output

impedance.

2Test is for two tones separated by 1 MHz for IFs at 70 MHz and 250 MHz at –23 dBm per tone input.

3Low Level Clamp is selected by connecting pin CLLO to the negative supply, while pin CLHI is left floating. Clamping can be set at lower levels by connecting pin

CLLO and CLHI to the negative supply through an external resistor.

4High Level Clamp is selected by connecting pin CLHI to the negative supply, while pin CLLO is left floating, this allows the maximum linear range of the device to

be utilized.

5Output clamp levels are measured for hard clamping with a +3 dBm input level. Valid for a maximum input level of +8 dBm/200

Ω = 3.2 V p-p—differential.

6Measured as the change in output phase when the input level is changed from –53 dBm to +8 dBm (i.e., from linear operation to clamping).

7Ratio of the differential output signal (referenced to the input) to the common-mode input signal presented to all input pins.

8Ratio of signal on supply to differential output (<500 kHz).

Specifications subject to change without notice.

ABSOLUTE MAXIMUM RATINGS

Parameter

Min

Max

Units

Single Supply Voltage

–0.5

11.5

Positive Supply Voltage

–0.5

5.75

Negative Supply Voltage

–5.75

0.5

Input Power

dBm

Storage Temperature

–65

+150

°C

Junction Temperature

+150

°C

ESD Protection

EXPLANATION OF TEST LEVELS

100% production tested.

II.

100% production tested at +25

°C, and guaranteed by

design and analysis at temperature extremes.

III. Sample tested only.

IV. Parameter guaranteed by design and analysis.

Parameter is typical value only.

VI. 100% production tested at +25

°C, and sample tested at

temperature extremes.

ORDERING GUIDE

Model

Temperature Range

Package Description

Package Option

AD6630AR

–40

°C to +85°C (Ambient)

16-Lead Wide Body SOIC

R-16

AD6630AR-REEL

–40

°C to +85°C (Ambient)

AD6630AR on 1000 PC Reel

AD6630R/PCB

Evaluation Board with AD6630AR

CAUTION

ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily

accumulate on the human body and test equipment and can discharge without detection.

Although the AD6630 features proprietary ESD protection circuitry, permanent damage may

occur on devices subjected to high energy electrostatic discharges. Therefore, proper ESD

precautions are recommended to avoid performance degradation or loss of functionality.

WARNING!

ESD SENSITIVE DEVICE

AD6630PCB Scheda tecnica(PDF) 3 Page - Analog Devices

AD6630PCB Scheda tecnica(HTML) 3 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8

Scheda tecnica Scarica

Link URL