SDA datasheet(8/29 Pages) EXAR

8 / 29 page

d C

ell D

Diig

giitta

all P

Prro

grra

blle

e P

err M

ntt S

stte

8/29

Rev. 1.0.1

PIN ASSIGNMENT

Fig. 4: XRP7724 Pin Assignment

PIN DESCRIPTION

Name

Pin Number

Description

VCC

Input voltage. Place a decoupling capacitor close to the controller IC. This input is used

in UVLO fault generation.

DVDD

1.8V supply input for digital circuitry. Connect pin to AVDD. Place a decoupling

capacitor close to the controller IC.

VCCD1-2

VCCD3-4

23,34

Gate Drive supply. Two independent gate drive supply pins where pin 34 supplies

drivers 1 and 2 and pin 23 supplies drivers 3 & 5. One of the two pins must be

connected to the LDO5 pin to enable two power rails initially. It is recommended that

the other VCCD pin be connected to the output of a 5V switching rail(for improved

efficiency or for driving larger external FETs), if available, otherwise this pin may also

be connected to the LDO5 pin. A bypass capacitor (>1uF) to PAD is recommended for

each VCCD pin with the pin(s) connected to LDO5 with shortest possible length of etch.

AGND

Analog ground pin. This is the small signal ground connection.

GL_RTN1-4

39,33, 28,22

Ground connection for the low side gate driver. This should be routed as a signal trace

with GL. Connect to the source of the low side MOSFET.

GL1-GL4

38,32, 27,21

Output pin of the low side gate driver. Connect directly to the gate of an external N-

channel MOSFET.

GH1-GH4

36,30, 25,19

Output pin of the high side gate driver. Connect directly to the gate of an external N-

channel MOSFET.

LDO3_3

AGND

CPLL

AVDD

VOUT1

VOUT2

VOUT4

GPIO0

GPIO1

GL2

LX2

GH2

BST2

GL_RTN3

GL3

LX3

GH3

BST3

VCCD3-4

VOUT3

Exposed Pad: AGND

XRP7724

TQFN

7mm X 7mm

SDA

GL_RTN2

SDA Scheda tecnica(PDF) 8 Page - Exar Corporation

SDA Scheda tecnica(HTML) 8 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Scheda tecnica Scarica

Link URL