ADMP621 datasheet(10/16 Pages) AD

10 / 16 page

ADMP621

Data Sheet

When long wires are used to connect the codec to the ADMP621,

a source termination resistor can be used on the clock output of

the codec instead of a buffer to minimize signal overshoot or

ringing. Match the value of this resistor to the characteristic

impedance of the CLK trace on the PCB. Depending on the

drive capability of the codec clock output, a buffer may still be

needed, as shown in Figure 17.

SLEEP MODE

The microphone enters sleep mode when the clock frequency falls

below 1 kHz. In this mode, the microphone data output is in a

high impedance state. The current consumption in sleep mode

is less than 5.5 µA.

The ADMP621 enters sleep mode within 1 ms of the clock

frequency falling below 1 kHz. The microphone wakes up

from sleep mode and begins to output data 32,768 cycles after the

clock becomes active. For a 3.072 MHz clock, the microphone

starts to output data in 10.7 ms. For a 2.4 MHz clock, the

microphone starts to output data in 13.7 ms. The wake-up

time, as specified in Table 2, indicates the time from when the

clock is enabled to when the ADMP621 outputs data within 3 dB

of its settled sensitivity.

START-UP TIME

The start-up time of the ADMP621 from when the clock is

active is the same as the wake-up time. The microphone starts up

32,768 cycles after the clock is active.

Rev. 0 | Page 10 of 16

ADMP621 Scheda tecnica(PDF) 10 Page - Analog Devices