IN+

IN-

LM48310

www.ti.com

SNAS430D – NOVEMBER 2007 – REVISED MAY 2013

AUDIO AMPLIFIER INPUT CAPACITOR SELECTION

Input capacitors may be required for some applications, or when the audio source is single-ended. Input

capacitors block the DC component of the audio signal, eliminating any conflict between the DC component of

the audio source and the bias voltage of the LM48310. The input capacitors create a high-pass filter with the

f = 1 / 2

Where

•

(1)

The input capacitors can also be used to remove low frequency content from the audio signal. Small speakers

cannot reproduce, and may even be damaged by low frequencies. High pass filtering the audio signal helps

protect the speakers. When the LM48310 is using a single-ended source, power supply noise on the ground is

seen as an input signal. Setting the high-pass filter point above the power supply noise frequencies, 217Hz in a

GSM phone, for example, filters out the noise such that it is not amplified and heard on the output. Capacitors

with a tolerance of 10% or better are recommended for impedance matching and improved CMRR and PSRR.

AUDIO AMPLIFIER GAIN

The gain of the LM48310 is internally set to 12dB. The gain can be reduced by adding additional input resistance

Figure 31. In this configuration, the gain of the device is given by:

Where

•

•

•

(2)

Figure 31. Reduced Gain Configuration

SINGLE-ENDED AUDIO AMPLIFIER CONFIGURATION

The LM48310 is compatible with single-ended sources. When configured for single-ended inputs, input

capacitors must be used to block and DC component at the input of the device. Figure 32 shows the typical

single-ended applications circuit.

Copyright © 2007–2013, Texas Instruments Incorporated

Submit Documentation Feedback

13

Product Folder Links: LM48310