www.austriamicrosystems.com/LDOs/AS1369

Revision 1.7

3 - 21

AS1369

Datasheet - Absolute Maximum Rat i ngs

5 Absolute Maximum Ratings

Stresses beyond those listed in Table 2 may cause permanent damage to the device. These are stress ratings only, and functional operation of

the device at these or any other conditions beyond those indicated in Electrical Characteristics on page 4 is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect device reliability.

Table 2. Absolute Maximum Ratings

1

1. The AS1369 uses an internal protective structure against light influence. However, exposing the WLP package to direct light could

cause device malfunction.

Parameter

Min

Max

Units

Comments

Electrical Parameters

Input Supply Voltage

-0.3

+7

V

Shutdown Input Voltage

-0.3

+7

V

Output Voltage

-0.3

+7

V

Short-circuit protected

Input/Output Voltage

2

-0.3

+7

V

Latch-Up

-100

+100

mA

Norm: JEDEC 78

Electrostatic Discharge

ESD

2

kV

Norm: MIL 883 E method 3015

500

V

CDM JESD22-C101C methods

Temperature Ranges and Storage Conditions

Thermal Resistance,

3

3. Exceeding the maximum allowable dissipation will cause excessive device temperature and the regulator will go into thermal shutdown.

345

ºC/W

The maximum allowable power dissipation is a function of the

ambient thermal resistance (

dissipation at any ambient temperature is calculated as:

(EQ 1)

Where:

The value of

Operating Junction Temperature

-40

+125

ºC

Storage Temperature Range

-65

+150

ºC

Package Body Temperature

+260

ºC

The reflow peak soldering temperature (body temperature)

specified is in accordance with IPC/JEDEC J-STD-020

“Moisture/Reflow Sensitivity Classification for Non-Hermetic

Solid State Surface Mount Devices”.