www.austriamicrosystems.com/AS5263

Revision 1.4

13 - 37

AS5263

Datasheet - Detailed Descr i pti on

Figure 8. Overview of the Angular Output Voltage

Figure 8 gives an overview of the different ranges. The failure bands are used to indicate a wrong operation of the AS5263. This can be caused

due to a broken supply line. By using the specified load resistors, the output level will remain in these bands during a fail. It is recommended to

set the clamping level CLL above the lower failure band and the clamping level CLH below the higher failure band.

Clamping Region Low

Failure Band Low

0

4

CLL

CLH

96

100

Failure Band High

Application Region

Clamping Region High

T2Y

T1Y