RL78 datasheet(29/42 Pages) RENESAS

Il numero della parte	RL78

Spiegazioni elettronici	In-Circuit Emulator

PDF	42 Pages

Scroll/Zoom	100%

Produttore elettronici	RENESAS [Renesas Technology Corp]

Homepage	http://www.renesas.com

Logo

29 / 42 page

QB-RL78L1C In-Circuit Emulator

CHAPTER 2

SETUP PROCEDURE

R20UT2703EJ0200

Rev.2.00

Page 29 of 42

Jan 31, 2014

Figure 2-7 Where GND Wire Can Be Connected

Adjust the height of the QB-RL78L1C with the front space adapter and the rear space adapter and ensure

isolation from the target system.

(d) Precautions related to emulation probe

<1> Be careful that stress of the emulation probe is not placed on the target connector.

Moreover, when

removing the emulation probe, remove it slowly while pressing down on the exchange adapter with a

finger so that there is no stress on the target connector.

<2> Be sure to connect the GND wire of the emulation probe to the QB-RL78L1C and the target system.

it cannot be connected, the impedance of the cable is unstable and could bring about lowering of signal

transmission characteristics or distortion of the output waveform for an input waveform.

(K)

(J)

L = 60 mm

24.7 mm

34.3 mm

User system

RL78 Scheda tecnica(PDF) 29 Page - Renesas Technology Corp