Datasheet

BMM150 Geomagnetic Sensor

Page 52

BST-BMM150-DS001-01 | Revision 1.0 | April 2013

Bosch Sensortec

© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to

third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.

Note: Specifications within this document are subject to change without notice.

9.5 Handling instructions

This device has built-in protections against high electrostatic discharges or electric fields (e.g.

2kV HBM); however, anti-static precautions should be taken as for any other CMOS component.

Unless otherwise specified, proper operation can only occur when all terminal voltages are kept

within the supply voltage range. Unused inputs must always be tied to a defined logic voltage

level.

We recommend careful handling of the WLCSP to avoid chipping from the bare silicon.

Note: It is strongly recommended to mount the WLCSP device without any underfill. The

specified electrical parameters might be influenced when using underfill material.

Please read our HSMI document for more details.