376 datasheet(43/95 Pages) INTEL

43 / 95 page

376 EMBEDDED PROCESSOR

240182 – 21

Idle states are shown here for diagram variety only Write cycles are not always followed by an idle state An active bus

cycle can immediately follow the write cycle

Figure 46 Various Non-Pipelined Bus Cycles (Zero Wait States)

Non-Pipelined Bus Cycles

Any bus cycle may be performed with non-pipelined

timing For example Figure 46 shows a mixture of

non-pipelined read and write cycles

Figure 46

shows that the fastest possible non-pipelined cycles

have two bus states per bus cycle The states are

named T1 and T2 In phase one of T1 the address

signals and bus cycle definition signals are driven

valid and to signal their availability address strobe

(ADS) is simultaneously asserted

During read or write cycles the data bus behaves as

follows If the cycle is a read the 80376 floats its

data signals to allow driving by the external device

being addressed The 80376 requires that all data

bus pins be at a valid logic state (HIGH or LOW)

at the end of each read cycle when READY is

asserted

The system MUST be designed to

meet this requirement

If the cycle is a write data

signals are driven by the 80376 beginning in phase

two of T1 until phase one of the bus state following

cycle acknowledgement

376 Scheda tecnica(PDF) 43 Page - Intel Corporation