AN4444 datasheet(35/68 Pages) STMICROELECTRONICS

Il numero della parte	AN4444

Spiegazioni elettronici	ST7590 PRIME compliant power line networking SoC design guide

PDF	68 Pages

Scroll/Zoom	100%

Produttore elettronici	STMICROELECTRONICS [STMicroelectronics]

Homepage	http://www.st.com

Logo

35 / 68 page

DocID025925 Rev 2

35/68

AN4444

ST7590 reference design description

Figure 25. Montecarlo simulation of the reception external amplifier with automatic attenuation

8.1.4

Zero crossing coupling

The zero crossing coupling circuit is aimed at providing a bipolar (AC) signal synchronous

with the mains network voltage to the ZC_IN pin. This signal must be centered on VSS and

limited to ± 5 V peak (see Part 1 of Section 13: References on page 63).

The isolated zero crossing circuit is realized through an optocoupler in non-inverting

configuration. Neutral and phase lines are brought to the optocoupler through 33 k



resistors in series, as represented in Figure 26. The STTH1L06A diode protects photodiode

during negative half-wave. The three 33 k

 series resistors limit the photodiode input

current to nearly 2 mA rms at 230 V AC. Having two resistors on the L line helps preventing

short-circuits in case of resistor degradation.

Figure 26. Isolated zero crossing coupling circuit

AN4444 Scheda tecnica(PDF) 35 Page - STMicroelectronics