Safety instructions

AN2835

4/21

Doc ID 15073 Rev 1

1

Safety instructions

Warning:

The demonstration board must be used in a suitable

laboratory by qualified personnel who are familiar with the

installation, use, and maintenance of electrical systems.

Intended use

The demonstration board is designed for demonstration purposes only, and must not be

used for domestic installations or for industrial installations. All technical data, including the

information concerning the power supply and working conditions, should only be taken from

the documentation included in the pack and must be strictly observed.

Installation

The installation instructions for the demonstration board must be taken from the present

document and strictly observed. The components must be protected against excessive

strain, and in particular, no components are to be bent, or isolating distances altered during

transportation, handling or use. The demonstration board contains electrostatically sensitive

components that are prone to damage through improper use. Electrical components must

not be mechanically damaged or destroyed (to avoid potential risk and personal injury).

Electrical connection

Applicable national accident prevention rules must be followed when working on the mains

power supply. The electrical installation must be carried out in accordance with the

appropriate requirements (e.g. cross-sectional areas of conductors, fusing, and PE

connections).

Board operation

A system architecture which supplies power to the demonstration board must be equipped

with additional control and protective devices in accordance with the applicable safety

requirements (e.g. compliance with technical equipment and accident prevention rules).