AN3972

Demo setup

Doc ID 022161 Rev 1

17/21

5.

Turn on one or more ZigBee smartplugs; make sure that the smartplug is linked to the

coordinator (STM3210C-EVAL board with daughterboard), in this case the connection

icon on the smartplug LCD should show the red light blinking; push the button on the

upper right on the smartplug to link/unlink to the coordinator.

6.

Refresh Internet Explorer

Figure 8.

Smartplug list detail of Smart Home Information web page

7.

Now it is possible to control the remote ZigBee smartplug

8.

To change the IP address, the user must power off the board and connect to it using the

RF interface. For example, using STARTKIT M24LR64. In this case the user should

read the block 0 of the EEPROM DUAL IFs, 4 bytes, reading the actual IP address.

Figure 9.

RFID PC user interface

9.

The user can easily change this value, putting the new IP address in HEX, for example,

writing 192.168.0.3 --> C0h, A8,h 00h, 03h.

Figure 10.

Writing details of RFID PC user interface