UM1535 datasheet(18/39 Pages) STMICROELECTRONICS

18 / 39 page

Working with pre-flashed software

UM1535

18/39

Doc ID 023036 Rev 2

Please be sure to disable your firewall or setup new firewall rules in order to enable

DHCP/TFTP traffic.

2.9

Updating the pre-flashed software

This section focuses on updating the contents of serial NOR Flash with default binary

images available on ST Web site. It also focuses on updating NAND Flash.

Updating the contents of Flash memory on SPEAr evaluation boards is a recommended

step. It is possible to update the pre-flashed software delivered by default with a SPEAr

evaluation board without installing the STLinux distribution.

The procedure for the update involves the installation and use of the USB Flasher tool

provided by ST.

This tool is a graphical interactive application, which can be downloaded from ST company

site, which also provides download for updated binary images (for each evaluation board

type) to be used with the USB Flasher. The use of the USB Flasher for other purposes and

scenarios is explained in the help pages embedded in the tool itself.

2.9.1

Installing the USB Flasher

The USB flasher tool must be installed on a Windows PC.

Before setting up the flasher tool, download and install an updated TCL package. The

recommended TCL software is ActiveTCL, available free of charge. The latest TCL version

(8.5) can be downloaded from the following supplier site:

http://www.activestate.com/activetcl/

UM1535 Scheda tecnica(PDF) 18 Page - STMicroelectronics