UM1547 datasheet(25/51 Pages) STMICROELECTRONICS

25 / 51 page

DocID023232 Rev 5

25/51

UM1547

AT command list

3.33

ShowConnection

This command is used to display the details of active links.

3.33.1

Syntax

at+ab ShowConnection

3.33.2

Responses

Reply format with active connection:

Channel ID, Remote Device BD Address, Status, Profile

4cb199dccd22

Connected IAP

Reply without active connection:

No Device Connected

3.34

ShowDev

The ShowDev command is used to list the contents of the Bond Table.

3.34.1

Syntax

AT+AB ShowDev

3.34.2

Responses

This command returns the list of all the devices bonded, identified by their BD address.

3.35

SmartCableSetup

The SmartCableSetup command is used to enable and configure a Smart Cable device. A

device's BD address is specified in order to automatically establish a connection, replacing

the need for AT connection commands. This command will override the dynamic

configuration of a Smart Cable device until the DeleteSmartCable command is issued; it is

saved in non-volatile memory.

3.35.1

Syntax

AT+AB SmartCableSetup [BD address] [Attempts] [Interval]

Where [BD address] is the BD address of the remote device to page and attempt to connect.

[Attempts] 0 - 999 is the number of pages that will be attempted to the specified device until

a connection is successful. A value of 0 will not automatically page the remote device. A

value of 1000 will perform unlimited pages until the connection is switched from command

mode to bypass mode to exchange data.

[Interval] 1-1000 is the number of 100 ms intervals (0.1 sec to 100 sec) between page

attempts. This interval is in addition to the amount of time required by the page attempt

itself.

UM1547 Scheda tecnica(PDF) 25 Page - STMicroelectronics

UM1547 Scheda tecnica(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

Scheda tecnica Scarica

Link URL